Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

format bootflash: command fails on 7513 router

Trying to reformat bootflash to load new boot image but the command fails with unspecified error. dir bootflash: command fails with bad device info block error. router boots fine and show version shows the bootldr version. any idea how i can reformat bootflash in this situation? thank you in advance.

1 REPLY
Silver

Re: format bootflash: command fails on 7513 router

You just try squeeze command. Then it show again same error it seems that the issue is caused by a HW failure. Better to replace it.

147
Views
0
Helpful
1
Replies