Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

FWSM Archive Management

I'm again needing some assistance on this issue.

I finally got the SNMP running to perform inventory on FWSM, but am now running into an issue with Config Archive. I'm SSH'n directly to the FWSM (no session to context) via IP. The error from RME is:

"CM0151 PRIMARY RUNNING Config fetch failed for FWSM_Slot_# Cause: Could not enter ENABLE Mode from USER Mode on Device.TELNET: Failed to establish TELNET connection to <IP ADDRESS> - Cause: connect timed out."

I'm not sure why TELNET is being referenced. SSH is my primary connection method and works fine when accessing the FWSM directly via putty/ssh session.

Please see the attached excerpt from "sho log" while performing a sync archive. Also attached is the dcmaservice.log produced using debug mode.

I cant ascertain from either of these 2 logs, what is preventing the entry into privledge mode.

thanks Bruce

5 REPLIES
Cisco Employee

Re: FWSM Archive Management

This is CSCsx69504 and CSCsy24049. A patch for both is available from TAC.

New Member

Re: FWSM Archive Management

ahhh...thanks J, appreciate the info...I'll engage TAC...

Bruce

New Member

Re: FWSM Archive Management

hey J,

I engaged TAC, and as yet, they have not provided the patches...the engineer I'm working with advises (since April 2) "the development team is researching the problem".

Is the patch you referrenced for general "consumption"?

thanks

Bruce

Cisco Employee

Re: FWSM Archive Management

Yes. The patch has been shown to work in quite a few customer environments.

New Member

Re: FWSM Archive Management

thanks for the info...guess i'll just have to standby until they finish...

213
Views
0
Helpful
5
Replies