getting EMC SMARTS to recognise CISCO-EPM-NOTIFICATION-MIB traps
Has anyone found a way of getting EMC SMARTS to recognise CISCO-EPM-NOTIFICATION-MIB traps (As sent by CiscoWorks etc.)? In particular I'm interested in getting it to recognize the Active and Clear states.
Re: getting EMC SMARTS to recognise CISCO-EPM-NOTIFICATION-MIB t
INCHARGE-OI needs to be configured to get traps from the Trap-Adapter. I believe in the out of box trap_mgr.conf file this trap is already defined. If not configured it as follows or something similar.
So just enable the trap adapter and configure the notification list so you filter out all the trap events you don't care about.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.