Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Getting information about configured devices

Is there any smart way to have information when devices are really configured. Now i am trying to use automated action(rme4.0.2-tools-syslog.)

I have configured rme send email when syslog message CONFIG_I appears. Problem is that when you enter conf terminal in devices and "come back" without configuring you got CONF_I and rme send email. So lot of unnecessary emails. Any experience. I want email only if device is really configured.(running/startup config changed)

Juha

1 REPLY
Bronze

Re: Getting information about configured devices

check the following link, table 14-2 shows the list of messages that trigger a config fetch, this should help you to define the automated action for config change :

http://www.cisco.com/en/US/products/sw/cscowork/ps2073/products_user_guide_chapter09186a0080357777.html

89
Views
0
Helpful
1
Replies
CreatePlease to create content