07-12-2006 11:53 AM
Just wondering if anyone knows how to configure CNA to send out a notification when a cluster member goes down? I've looked under monitor -> event notification, enabled 0 to 3 notication but didn't get the what i was looking for.
FYI I have a mixture of 3500xl series switches, 2924XLs and 3560 switches. I'm planning to switch to communities, but thats still going to take a bit of time and I need some for of notification in the interim.
07-18-2006 07:37 AM
All the devices for the topology of a community are derived from the CDP (Cisco Device Protocol) table of Cisco IOS. Therefore, the Topology view shows duplicate devices when CDP discovers duplicate devices.This happens for a single device when the command show cdp neighbor is entered.
http://www.cisco.com/en/US/partner/products/ps5931/prod_release_note09186a008065ca3c.html#wp690854
05-25-2007 01:30 PM
Actually during another post, I figured out how to solve this particular issue. Basically if i put notification on the uplink port that the cluster member is on and it does pretty much what i was looking for.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide