Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Grouping switches by location

All the switches have the same community strings.

The LMS 3.2  is installed on win server 2003.

I used the following Rule Expression in the rule window:

Device.ManagementIpAddress equals "the ip adr" OR

Device.ManagementIpAddress equals "the ip adr" OR

Device.ManagementIpAddress equals "the ip adr" OR

---- and so on ----

Device.ManagementIpAddress equals "the ip adr"

I can successfully see the numbers of grouped switches in the Membership edit window and in the final Summary edit window. But the same number of switches is not appearing in Topology services window and Network Topology window. Can anyone tell me why this is happening?

Thanks in advance.

Tesema

2 REPLIES

Grouping switches by location

Probably you look in the layer 2 topology view.

You should look in the userdefined groups below and there find the group you defined above.

Cheers,

Michel

New Member

Re: Grouping switches by location

Hello,

Thanks. Actually, I am looking in the User Defined Groups, since the groups are made under Topology Groups >> CS@servername >> User Defined Groups. Looked at Topology Services window. Any other idea?

Tesema

269
Views
0
Helpful
2
Replies