Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Help in LMS 3.0

1- I configured LMS 3.0 support 5000 node I am running discovery and discovered the nods

2- I have 100 branches connected over frame relay

3- I have 2 deferent frame relay cloud (redundant links)

4- I don't have DNS in my network

5- I discover by Ethernet IPs

MY question

1 - All discovery nodes have IP and I need names how I can resolve IP to name with out DNS

2 - All nodes in topology single nodes not like point to multi point or star I cant see the frame relay in topology between headquarter and anther branches

Cisco Employee

Re: Help in LMS 3.0

You can still have name resolution without DNS. To do this, you need to setup a hosts file on the server that maps IPs to hostnames (i.e. /etc/hosts on Solaris and C:\WINDOWS\system32\drivers\etc\hosts on Windows).

For Topology to work properly, you need to have CDP enabled. CDP is not enabled by default on frame-relay multipoint interfaces, so you will need to explicitly configure "cdp enable" under those interfaces.

New Member

Re: Help in LMS 3.0

The HQ to branches connection is

• FR "Point-to-Point" configured on the sub interfaces.

So just to enable CDP it will work like point to multi point

Cisco Employee

Re: Help in LMS 3.0

If you manually enable CDP on those interfaces such that show cdp neighbor looks like you want it to, then run a new Data Collection, you should see the interconnections on your topology map.