Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Help me understand Change Audits and Config backups...

How does RME know a configuration change has been made to a device and back that config up? Does it rely on the configured schedule or does something get sent to RME from the device? If it does, does syslog have to be setup for that to occur or is it something else?

I guess I have really the same questions on how the configuration audit works.

1 ACCEPTED SOLUTION

Accepted Solutions
Red

Re: Help me understand Change Audits and Config backups...

*Apr 23 04:42:25: %SYS-5-CONFIG_I: Configured from console by vty0 (14.32.100.33)

5 REPLIES
Red

Re: Help me understand Change Audits and Config backups...

It is based on syslog

RME -> Admin -> Config Management -> General Setup -> Change Probe Setup

Community Member

Re: Help me understand Change Audits and Config backups...

Thank you.

Community Member

Re: Help me understand Change Audits and Config backups...

Oh yea. One more question. What is the logged message for this and what severity is it? I'm in the process of configuring the devices to log their messages to a syslog server. I've done quiet a few and hope I didn't screw up by logging levels starting at 4(warning),3,2,2,1 and 0. I have a feeling this message is higher...a 5 or 6. If so, I did mess up!!

Red

Re: Help me understand Change Audits and Config backups...

*Apr 23 04:42:25: %SYS-5-CONFIG_I: Configured from console by vty0 (14.32.100.33)

Community Member

Re: Help me understand Change Audits and Config backups...

That's what I was afraid of....

I guess I'm gonna have to change all of the ones I've configured to start at 5 and not 4!

Oh well.

129
Views
5
Helpful
5
Replies
CreatePlease to create content