Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

help required in configuring telnet

Hi,

We have two PIX 515E firewalls working in HA mode.

I wanted to configure telnet access to firewalls from outside interface.

PIX version is 6.3(5)

I kept PC outside to outside interfaces.

PIX outside IP is 10.10.200.3, inside IP is 10.10.202.5 corresponding virtual IPs are 10.10.200.2 and 10.10.202.7

I have tried following configurations:

pix(config)#telnet 0 0 inside

pix(config)#telnet 0 0 outside

pix(config)#telnet 10.10.200.0 255.255.255.0 outside

pix(config)#telnet 10.10.202.0 255.255.255.0 inside

pix(config)#telnet 10.10.200.200 255.255.255.255 outside

I am able to telnet from internal interface side using inside ip address.

But from outside test pc with IP 10.10.200.200 I am not able to telnet to PIX.

I enabled logging console 5.

when I tried to telnet to outside virtual IP it is not showing any traffic to firewall.

If I try to outside interface I am able to see the traffic like

packets received from source 10.10.200.200 to 10.10.200.3

any help in this configuration. I wanted to telnet firewall from test pc.

Regards

SKRAO

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: help required in configuring telnet

from outside u have to give ssh access

2 REPLIES
New Member

Re: help required in configuring telnet

from outside u have to give ssh access

New Member

Re: help required in configuring telnet

Either using SSH or IPSEC.

You can't telnet to outside interface without using above due to security

136
Views
0
Helpful
2
Replies