Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

High Utilization alerts

From time to time I get high utilization alerts on some of my 100mb uplinks. Is there a way within LMS to determine the causes of these alerts? Or is my best method to get a portable sniffer and capture the packets and try and determine this way what the cause is?

Any advice would be appreciated.

1 REPLY
Blue

Re: High Utilization alerts

That's one way to go about it. A more user-friendly means than a sniffer is using a probe w/ the associated reporting sw. The other alternatives are setting up NetFlow or sFlow on both or at least one end of the links to do the same traffic analysis.

113
Views
0
Helpful
1
Replies