How can I customize the interface threshold in LMS 2.5?
In CiscoWorks LMS 2.5, is there any way to customize the threshold for a specific interface in a specific device? for example, just change the theshold for the Internet router's outside interface and others keep the global parameter.
Re: How can I customize the interface threshold in LMS 2.5?
My question is how change the threshold for a specific interface. for example, I have 10EA routers and wants to change only the 1st router's f0/0. the 2nd interface of the 1st and the other routers(2nd to 10th) are same threshold.
The doc explained how to change for interface but not for specific such as my example. please guide me detain rather than general.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...