Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How does LMS show the serial number of Gbic

Hi

I have over 100 switches in the network

and I would like to get the serial number for Gbic in each switches

How can I use LMS to show the serial number of Gbic ?

Can I use Inventory Report in RME for this case ?

Thank you.

3 REPLIES
Blue

Re: How does LMS show the serial number of Gbic

Unfortunately, I don't think this has changed in LMS. See this previous discussion on the subject:

http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=Network%20Management&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.2cc29934/2#selected_message

Though you could use the NetShow function of RME to collect such info against individual interfaces on a rather hit-or-miss basis:

show interface status

show interface gigabitEthernet

show controller ethernet-controller gigabitEthernet phy

show inventory

Cisco Employee

Re: How does LMS show the serial number of Gbic

This is correct. I have a bug open requesting this support, but it has not been implemented yet. The bug ID is CSCsz48654.

New Member

Re: How does LMS show the serial number of Gbic

Thank you very much

195
Views
10
Helpful
3
Replies
CreatePlease to create content