Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

how to change configuration using SNMP

i have 3560 device on remote site and due to some wrong configuration tacac communication is getting failed and switch is now directly asking for password however it gives authorization failed when i put in.

is there any way by which i can fetch the config via snmp and change configuration and reconfigure the switch.

i tried using cwconfig features but getting authentication failed error is popping up.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: how to change configuration using SNMP

You can use any snmp utlity...you would just query / set the same snmp OID's

3 REPLIES
Cisco Employee

Re: how to change configuration using SNMP

Community Member

Re: how to change configuration using SNMP

Hi davistan,

this require hpopenview and solaris. i dont have any of them, is this still possible ?

Cisco Employee

Re: how to change configuration using SNMP

You can use any snmp utlity...you would just query / set the same snmp OID's

396
Views
5
Helpful
3
Replies
CreatePlease to create content