Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to Change Utilization Threshold

The current utilization threshold in DFM is at 40% for router's where can this vailue be increased?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: How to Change Utilization Threshold

To increase this, go to DFM > Configuration > Polling and Thresholds > Managing Thresholds. Then, select DFM > System Defined Groups > Interface Groups > Serial, and click Edit. Adjust the Utilization threshold, then click Save, then click OK. Then go to Apply Changes, and apply your changes.

2 REPLIES
Cisco Employee

Re: How to Change Utilization Threshold

To increase this, go to DFM > Configuration > Polling and Thresholds > Managing Thresholds. Then, select DFM > System Defined Groups > Interface Groups > Serial, and click Edit. Adjust the Utilization threshold, then click Save, then click OK. Then go to Apply Changes, and apply your changes.

New Member

Re: How to Change Utilization Threshold

found it!!! Was in the neighborhood.

thanks for all tour help!!

122
Views
0
Helpful
2
Replies