How to Clear "last seen" from "link status" in DCNM GUI
Recently during a trouble shooting session to identify if we had a problem with a cable or port via MDS 9710 switch. The device alias, port WWN, FcId, switch interface, vender, etc. all picked up the B side of the setup after swapping cables. We have since resolved the issue being a downed port on B side. The cables for B side have been placed back where they belong. Now in my DCNM-SAN GUI for the device I get 2 listings. 1 for the current A side setup and 1 for the cable swap with the B side. The B side settings all have "last seen" and time stamp from when cables were swapped. I would like to know how to clear this result from GUI. Thanks
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.