Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to config RME Software Distribution to NOT use telnet--use SSH only to connect to Switch

We have LMS 3.2 installed. I am trying to use RME Software Distribution feature to upgrade switches’ IOS.  When I went to RME->Software Mgmt->Software Distribution->Distribute by Devices,  select one device, then software was doing verification, fail returned. The reason was:

“SWIM5001: Cannot connect to the device 192.168.6.53 using TELNET.”

Telnet has been disabled in all of our switches, we only allow SSHv2. Where can I config the CiscoWorks to not use telnet, and use SSH. I think it should be in Common Service, but just cannot find it.

Any help would be great.

Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
Blue

Re: How to config RME Software Distribution to NOT use telnet--u

The SWIM transport settings are under RME - Admin - Software Mgmt - View/Edit Preferences, i.e. http://hostname:1741/rme/SwimAdminAction.do

2 REPLIES
Blue

Re: How to config RME Software Distribution to NOT use telnet--u

The SWIM transport settings are under RME - Admin - Software Mgmt - View/Edit Preferences, i.e. http://hostname:1741/rme/SwimAdminAction.do

New Member

Re: How to config RME Software Distribution to NOT use telnet--u

Thanks a lot. I missed the check box there. It is working

correctly now.

686
Views
0
Helpful
2
Replies
CreatePlease to create content