Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

How to configure HighUtilization Threshold

Hello

I have CiscoWorks LMS 2.6 running.

I keep getting these high utilization notifications from my 6506 switch where the thresholds seems to be set to only 40%.

Can someone tell me how to configure the LMS or switch to set the utilization threshold to say about 80% ?

The following is what I get via SMTP from CiscoWorks:

EVENT ID                = 0000P4J

ALERT ID                = 00002ZJ

TIME                    = Fri 19-Mar-2010 15:01:20 VET

STATUS                  = Active

SEVERITY                = Critical

MANAGED OBJECT          = 192.168.100.11

MANAGED OBJECT TYPE     = Switches and Hubs

EVENT DESCRIPTION       = HighUtilization::Component=PORT-192.168.100.11/1.2 [Fa1/2] [** Member: EtherChannel Trunk Group to MER1 6506 **];OutputPacketRate=4330.4336  PPS;Type=ETHERNETCSMACD;CurrentUtilization=44.208015  %;InputPacketRate=5729.854  PPS;TrafficRate=5526002.0  BYPS;UtilizationThreshold=40;DuplexMode=FULLDUPLEX;MaxSpeed=100000000;

CUSTOMER IDENTIFICATION = AndreThompson

CUSTOMER REVISION       = 1.0

Thanks in advance.

- Andre

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: How to configure HighUtilization Threshold

Go to DFM > Configuration > Polling and Threshold > Managing Thresholds.  Select your device group, and click Edit.  Set the utilization threshold to the desired value, save your changes, then go to Apply Changes back under Polling and Threshold.

3 REPLIES
Cisco Employee

Re: How to configure HighUtilization Threshold

Go to DFM > Configuration > Polling and Threshold > Managing Thresholds.  Select your device group, and click Edit.  Set the utilization threshold to the desired value, save your changes, then go to Apply Changes back under Polling and Threshold.

New Member

Re: How to configure HighUtilization Threshold

Hi Joe

Thanks for your prompt response.

I just need to figure out which one of the device groups I need to select :-)

Thanks again.

Cisco Employee

Re: How to configure HighUtilization Threshold

According to the event you provided, the group would be "Switches and Hubs".

1050
Views
0
Helpful
3
Replies
CreatePlease to create content