How to configure IPM alert in IPM 2.6 for Windows?
I am trying to figure out if there is a way to configure IPM to send out an alert when the performace reaches or falls beyond certain threshold? In this case, I am trying to create a new HTTP operation. On the General tab > Latency Threshold Settings > Action Event Type, I select SNMP Trap & NMVT Alert. However, I did not see an option to configure where the alerts will be sent to, as well as, other alert settings. Thank you in advance.
Re: How to configure IPM alert in IPM 2.6 for Windows?
IPM does not send out the alerts itself. Instead, the device will send an SNMP trap if the trigger condition is met. Where these traps are sent depends on your device configuration. Make sure you have defined at least one trap recipient on your IP SLA source device, and make sure that you have configured:
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...