If you have congestion in your network that causes your users to complain, QOS might be the answer. It really depends on the specific applications in use, as well as your network. Sometimes more bandwidth is the right answer. If you have real time traffic like voice or video you definitely need QOS.
tcp or udp...damn, im not really sure on that...we are using analog cameras into a digital encoder to display the video via ip...that encoder is connected to a 3750 switch then to a 6509 switch where the mgmt vlan is configured...im still reading up on QoS, do you have to put the QoS configs on every switch it will hit for access of video?
Is it always jittery, or only when network traffic load is high? With your all LAN topology I would suspect packet loss as your primary problem. Do you see any interface errors on the 3750 encoder interface or 6509 interface connecting to your video display? Is it possible to test by connecting the video display to the 3750, or even directly to the output of the encoder to be sure it is a network issue?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...