How to have ACS and Locallogin devicecred. in LMS2.5 at the same time
We just installed LMS 2.5 and my experience is with former versions that you could have Locallogin credentials and tacacs credentials for each device configured in CW at the same time. However in this version I have only one set of fields for one or the other. Am I missing something here? Should I do something to get two sets of fields?
BTW: I am not talking about using/configuring login module for CW it self.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...