How to implement two default gateways on ASA5550 pair
Here's the scenario...
I have two ISPs (L3 and XO) each connected to it's own 3925E. Currently, I'm only receiving the default route from the ISPs. We essentially dedicate our L3 connection for Inbound traffic (e.g. Website hosting) and, the XO connection for outbound traffic (e.g. Internet browsing). We also currently terminate our Cisco VPN clients to a pair of ASA5520s hosted on the XO connection. We'd like to migrate those clients to a pair of ASA5550s and utilized the L3 connection. On the ASA5550s, I have an interface on the L3 subnet and an interface on the XO subnet. But, the default route on this ASA5550 pair points to the 3925E on the XO connection. The challenge is, how can I terminate Client IPSec tunnels to the L3 interface if the default gateway is pointing to XO. This asymetric routing will not allow phase I to establish. I have a feeling I can get around this with policy based routing or, Firewall context...but, looking for ideas at the moment!
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...