Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to load new mib into LMS 2.6

Hi folks!

can I load new mib into LMS2.6, in order to select the new mib Device Type into DCR?

Tks!!

Leonardo

3 REPLIES
Cisco Employee

Re: How to load new mib into LMS 2.6

Hi Leonardo,

LMS is pre-loaded with all MIB's required to manage the devices types it supports.

Is there a specific device type that you have concerns about? And if so, have you checked the supported device list to see if that device type is supported?

http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cw2000/cw2000e/e_4_x/rme405/rme405.htm

(note, if they are supported in RME, they are supported in DCR)

-J

New Member

Re: How to load new mib into LMS 2.6

Thanks for your answer!

I have this kind of device

lc7500Chassis 1.3.6.1.4.1.2745.1.4.2.1

I didn't found it on RME supported devices, for that it will be good to load a new mib about this device.

But... it's impossible... right?

TKS

Leonardo

Cisco Employee

Re: How to load new mib into LMS 2.6

This is a LANCAST device (1.3.6.1.4.1.2745 is LANCAST). You cannot add support for this device to LMS. However, assuming it supports generic mibII objects, RME will do some basic inventory collection for it.

164
Views
5
Helpful
3
Replies
CreatePlease to create content