Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

how to mange blade switch on LMS 2.6

I have new blade switch, with 5 blades, actually they have one host name.however in ciscoworks the 4 blades detected as device with ip address belongs to them, and showed as failed devices and unmanageable. should I removed this blades from DCR and added them on exclude list?

1 REPLY
Silver

Re: how to mange blade switch on LMS 2.6

Hi Elias,

i guess most members of the forum are not fortune tellers and therefore cannot have a look into the crystal ball to determine your blade switch type.

;-)

Please be a bit more precise:

What kind of chassis?

What kind of blades?

What is the used IOS or CATOS?

What Version of the LMS do you use??

And as generic answer: Yes you can add them to the exclude list and then they will not discovered anymore.

Best regards,

Frank

91
Views
0
Helpful
1
Replies