Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

How to monitor access ports to server on LMS 4.0

Hi everybody!

I would like to monitor access ports to servers in cases:

- When port to server down, alert appears in Fault Monitor panel

- Monitor when bandwidth utilization of access ports exceeds 60%.

I configured Fault Threshold on DFM>System Defined Groups>Access port Settings and Poller settings on the same group but it did not work when I shut a port to server.

Please help me!

Thanks and Best Regards

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

How to monitor access ports to server on LMS 4.0

By default Fault monitor manages Trunk Ports. You can check if the interface you worked on is managed :

Monitor > Fault Settings: Setup > Fault Device Details

You can check if the port/interface shows true as managed, which you tested.

-Thanks Vinod **Rating Encourages contributors, and its really free. **
2 REPLIES
Cisco Employee

How to monitor access ports to server on LMS 4.0

By default Fault monitor manages Trunk Ports. You can check if the interface you worked on is managed :

Monitor > Fault Settings: Setup > Fault Device Details

You can check if the port/interface shows true as managed, which you tested.

-Thanks Vinod **Rating Encourages contributors, and its really free. **
Community Member

How to monitor access ports to server on LMS 4.0

Thanks Vinod Arya!

I got it!

264
Views
0
Helpful
2
Replies
CreatePlease to create content