Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How to monitor gbic SFPs metrics using SNMP?

i have

Vendor Name           :   CISCO-FINISAR

Vendor Part Number    :   FTRJ1319P1BTL-C

Vendor Revision       :   0x42 0x20 0x20 0x20

and when i try to get info from telnet i get normal information

#sho interfaces transceiver

If device is externally calibrated, only calibrated values are printed.

++ : high alarm, +  : high warning, -  : low warning, -- : low alarm.

NA or N/A: not applicable, Tx: transmit, Rx: receive.

mA: milliamperes, dBm: decibels (milliwatts).

                                           Optical   Optical

           Temperature  Voltage  Current   Tx Power  Rx Power

Port       (Celsius)    (Volts)  (mA)      (dBm)     (dBm)

---------  -----------  -------  --------  --------  --------

Gi0/26       52.5       3.25      26.9      -5.7     -13.8

but i couldnot get from snmp can someone tell me if is some configure in device or  oid .

  • Network Management
Everyone's tags (5)
813
Views
0
Helpful
0
Replies