i have
Vendor Name : CISCO-FINISAR
Vendor Part Number : FTRJ1319P1BTL-C
Vendor Revision : 0x42 0x20 0x20 0x20
and when i try to get info from telnet i get normal information
#sho interfaces transceiver
If device is externally calibrated, only calibrated values are printed.
++ : high alarm, + : high warning, - : low warning, -- : low alarm.
NA or N/A: not applicable, Tx: transmit, Rx: receive.
mA: milliamperes, dBm: decibels (milliwatts).
Optical Optical
Temperature Voltage Current Tx Power Rx Power
Port (Celsius) (Volts) (mA) (dBm) (dBm)
--------- ----------- ------- -------- -------- --------
Gi0/26 52.5 3.25 26.9 -5.7 -13.8
but i couldnot get from snmp can someone tell me if is some configure in device or oid .