How to push a configuration change to the network devices

[palukuri77]

Hi,

I need to know about the procedure of how to push a configuration change(like changing a password) to all the registered network devices.

Our CiscoWorks version is 2.5

RME 4.0.2

Cisco View 6.1

Campus Manger 4.0

Device Fault Manager 2.0

[David Stanford · Accepted solution]

You'll want to do this through RME and you do it by going to RME -- Configuration Management and then select either Netconfig or Config Editor. You can then walk through the steps in these tools to push config changes to device(s).

[davidoh29]

Hi

I using RME Baseline Templates

to deploy RTR commands to group of 450 routers 800

series,

The problem is that i need to use the dymnamic

varaible of ip and I dont know what is the parameter

the ip is the default gateway and also is the device

name at the CISCOWORKS

here my example ;

+ rtr 69

+ type echo protocol ipIcmpEcho 1.71.254.253 source-ipaddr X.X.X.X

+ timeout 1000

+ threshold 40

+ frequency 86400

+ rtr schedule 69 life forever start-time now

+ exit