Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to push a configuration change to the network devices

Hi,

I need to know about the procedure of how to push a configuration change(like changing a password) to all the registered network devices.

Our CiscoWorks version is 2.5

RME 4.0.2

Cisco View 6.1

Campus Manger 4.0

Device Fault Manager 2.0

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: How to push a configuration change to the network devices

You'll want to do this through RME and you do it by going to RME -- Configuration Management and then select either Netconfig or Config Editor. You can then walk through the steps in these tools to push config changes to device(s).

2 REPLIES
Cisco Employee

Re: How to push a configuration change to the network devices

You'll want to do this through RME and you do it by going to RME -- Configuration Management and then select either Netconfig or Config Editor. You can then walk through the steps in these tools to push config changes to device(s).

New Member

Re: How to push a configuration change to the network devices

Hi

I using RME Baseline Templates

to deploy RTR commands to group of 450 routers 800

series,

The problem is that i need to use the dymnamic

varaible of ip and I dont know what is the parameter

the ip is the default gateway and also is the device

name at the CISCOWORKS

here my example ;

+ rtr 69

+ type echo protocol ipIcmpEcho 1.71.254.253 source-ipaddr X.X.X.X

+ timeout 1000

+ threshold 40

+ frequency 86400

+ rtr schedule 69 life forever start-time now

+ exit

119
Views
5
Helpful
2
Replies
CreatePlease to create content