How to remove devices shown in RME and not existing in DCR?
I have problem with some devices (in fact IP addresses) that was discovered and used by RME in the past but are not reachable anymore. They spoil statistics in RME (collection of inventory and configuration) however they do not exist in DCR. Do you have any ideas how to get rid of them?
Re: How to remove devices shown in RME and not existing in DCR?
Check Common Services > Device and Credentials > Reports > Devices not configured in ACS to see if your devices show up there. If they do, then you will need to either add those devices to ACS (temporarily) so you can remove them from DCR; or you will need to temporarily disable ACS integration, remove the devices from DCR, then re-enable integration.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...