Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

How to see 4500 switching capacity

If I run the following command on a 6500 series switch:

sh platform hardware capacity fabric

I get the following output:

Switch Fabric Resources
  Bus utilization: current: 0%, peak was 24% at 07:25:01 PDT Tue Aug 6 2013
  Fabric utilization:     Ingress                    Egress
    Module  Chanl  Speed  rate  peak                 rate  peak
    5       0        20G    0%    1% @11:29 06Oct14    0%    9% @16:03 17Jun11
    6       0        20G    0%    8% @16:03 17Jun11    0%    8% @07:25 06Aug13
    6       1        20G    0%    4% @09:40 01Oct14    0%    7% @13:53 30Jun12
    7       0        20G    0%    8% @07:25 06Aug13    0%    9% @16:03 17Jun11
    7       1        20G    0%    1% @04:40 04Oct14    0%    2% @07:24 06Aug13
    8       0         8G    0%   62% @17:19 26Sep12    0%   56% @17:19 26Sep12
  Switching mode: Module                                        Switching mode
                  5                                                        bus
                  6                                                       dcef
                  7                                                       acef
                  8                                                   crossbar

 

 

I want to see information similar to the above, but on a 4500 series switch. I can't seem to find a similar command. Help please?

49
Views
0
Helpful
0
Replies
CreatePlease to create content