Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

how to set up loopback# as source fro NTP and/or built-in DNS server ?

I have created a loopback# interface which I would like to be used as the router source interface for the NTP client and/or built-in DNS server so everything originating whithin the router has only one and unique IP address (such as: logging source-interface Loopback#)

The documentation explains how to create virtual interfaces but I cannot find how to associate them to the mentioned services except logging.

IOS is 12.4.15T.9

  • Network Management
1 ACCEPTED SOLUTION

Accepted Solutions
Blue

Re: how to set up loopback# as source fro NTP and/or built-in DN

For NTP, it's "ntp source [e.g. Loopback#]".

2 REPLIES
Blue

Re: how to set up loopback# as source fro NTP and/or built-in DN

For NTP, it's "ntp source [e.g. Loopback#]".

Blue

Re: how to set up loopback# as source fro NTP and/or built-in DN

For DNS, maybe this would do the trick:

! (from DNS view configuration mode)

dns forwarding source-interface [Vlan10]

221
Views
0
Helpful
2
Replies
This widget could not be displayed.