Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to setup SSH in LMS 2.6

What are the steps to configure SSH Telnet in LMS 2.6.

2 REPLIES
Cisco Employee

Re: How to setup SSH in LMS 2.6

Are you talking about adding the ssh/telnet credentials for a device or the transport protocol order? Or are you talking about the client LMS uses to telnet or ssh?

If you are talking about #1 this is done under CS Device Management.

#2 would be done under RME - Admin - Config Mgmt - Protocol

New Member

Re: How to setup SSH in LMS 2.6

{you'll need this if you don't already have SSH working from the topology maps}

If you're talking about right-click SSH access from Topology views, you'll need to do do the following on the workstation displaying the map view:

- Go to Control Panel -> Java Plug-In

- On the Advanced tab set the Java Runtime parameters to:

-DCMSSH={path to your SSH Program}

* In my case it reads: -DCMSSH=C:\Progra~1\PuTTY\Putty.exe

- Once this is done, hit apply and close all Browser windows and any running Java applets.

- Fire up LMS and give it a try

This is also found under Using Topology Services in the Campus Manager documentation.

118
Views
0
Helpful
2
Replies