Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to start DCR Server ?

Hi,

I am installing CWLMS-3.0-5K-K9 suite.While adding a device ,I am getting error in LMS console "DCR server is down...Please start DCR server".

From where i can start it?

5 REPLIES
Cisco Employee

Re: How to start DCR Server ?

DCRServer should be started automatically. Please post the output of the pdshow command.

Re: How to start DCR Server ?

I have same issue;

Z:\>pdshow DCRServer

Process= DCRServer

State = Administrator has shut down this server

Pid = 0

RC = 0

Signo = 0

Start = 6/14/2008 11:17:45 AM

Stop = 6/14/2008 6:52:08 PM

Core = Not applicable

Info = Application dependency stop: depends on stopped application(s).

Cisco Employee

Re: How to start DCR Server ?

Please post the entire pdshow output. According to this, other processes have been stopped.

How to start DCR Server ?

Please tell us how to start it.  This product is so sparsely documented. The dosc are there but so few are of much use and my pdshow says the dcrServer was never started so can someone answer the question on how to start it?

Other searches come up with the suggestion to use net start and net stop to start and stop all services but I have no DCRServer in NT services.

How to start DCR Server ?

Get a command prompt going inside the CSCOpx folder and type dcr

(its a bat and ini file that use each other methinks)

yay!

1546
Views
0
Helpful
5
Replies