cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
683
Views
0
Helpful
4
Replies

How to upgrade the Application image for WS-SVC-NAM-2

eemara949
Level 1
Level 1

Dear all,

from the Document file, the commmand that should be used to upgrade the application image is:

upgrade ftp-url [--install]

but it doesn't take the last word "install", how to use this command??

4 Replies 4

digisridhar
Level 1
Level 1

Hi,

To download and install a new maintenance image on the NAM, use the upgrade command.

upgrade ftp://user:passwd@host/full-path/filename

Eg:Root@localhost# upgrade ftp://alamo:ljljsdf@milton/dir65/abracadabr/dir65/upgrade_now

check this link for the procedure..

http://www.cisco.com/en/US/products/hw/modules/ps2706/products_configuration_example09186a008019cdf9.shtml

or

http://tools.cisco.com/search/display?url=http%3A%2F%2Fwww.cisco.com%2Fen%2FUS%2Fdocs%2Finterfaces_modules%2Fservices_modules%2Fnam%2Fnam_3_1%2Fswcg%2F78_15354.pdf&pos=7&strqueryid=9&websessionid=PZFslthpDwC3nCg8VBM_BB5 - Refer Page 85-86

Regards

Sridhar

hi my dear,

Iam asking about the application image not the maintenance!!

any help???

It's been a while since I have upgraded one of these things. Here is a good link to help you with your upgrade.

http://www.cisco.com/en/US/docs/interfaces_modules/services_modules/nam/nam_3_3/ICN/advcfg_ps5401_TSD_Products_Module_Installation_and_Configuration_Guide_Chapter.html#wp1035524

HTH,

Mark

P.S

The --install keyword clears and recreates all of the NAM partitions; this action is similar to restoring the factory-default state. The --install keyword is only applicable to the WS-SVC-NAM-1 and WS-SVC-NAM-2 modules. If you use the --install keyword, the previously stored reports and data (if any) will be lost.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco