Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to upgrade the Application image for WS-SVC-NAM-2

Dear all,

from the Document file, the commmand that should be used to upgrade the application image is:

upgrade ftp-url [--install]

but it doesn't take the last word "install", how to use this command??

4 REPLIES
New Member

Re: How to upgrade the Application image for WS-SVC-NAM-2

Hi,

To download and install a new maintenance image on the NAM, use the upgrade command.

upgrade ftp://user:passwd@host/full-path/filename

Eg:Root@localhost# upgrade ftp://alamo:ljljsdf@milton/dir65/abracadabr/dir65/upgrade_now

check this link for the procedure..

http://www.cisco.com/en/US/products/hw/modules/ps2706/products_configuration_example09186a008019cdf9.shtml

or

http://tools.cisco.com/search/display?url=http%3A%2F%2Fwww.cisco.com%2Fen%2FUS%2Fdocs%2Finterfaces_modules%2Fservices_modules%2Fnam%2Fnam_3_1%2Fswcg%2F78_15354.pdf&pos=7&strqueryid=9&websessionid=PZFslthpDwC3nCg8VBM_BB5 - Refer Page 85-86

Regards

Sridhar

New Member

Re: How to upgrade the Application image for WS-SVC-NAM-2

hi my dear,

Iam asking about the application image not the maintenance!!

New Member

Re: How to upgrade the Application image for WS-SVC-NAM-2

any help???

Re: How to upgrade the Application image for WS-SVC-NAM-2

It's been a while since I have upgraded one of these things. Here is a good link to help you with your upgrade.

http://www.cisco.com/en/US/docs/interfaces_modules/services_modules/nam/nam_3_3/ICN/advcfg_ps5401_TSD_Products_Module_Installation_and_Configuration_Guide_Chapter.html#wp1035524

HTH,

Mark

P.S

The --install keyword clears and recreates all of the NAM partitions; this action is similar to restoring the factory-default state. The --install keyword is only applicable to the WS-SVC-NAM-1 and WS-SVC-NAM-2 modules. If you use the --install keyword, the previously stored reports and data (if any) will be lost.

261
Views
0
Helpful
4
Replies