Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to use SNMP trap to monitor all the IP phones ?

Customer has a Cisco VG350 voice gateway.

They want to send the phone call status to other equipment through the SNMP trap.

The equipment should know that if the IP phone is ringing(3) status or not.

How could we monitor the 100 IP phones' status at the same time and send the information out?

The SNMP MIB from the CISCO-CCME-MIB.my

ccmeEphoneActivityStatus OBJECT-TYPE

    SYNTAX          INTEGER  {

                        onhook(1),

                        offhook(2),

                        ringing(3),

                        paging(4)

                    }

    MAX-ACCESS      read-only

    STATUS          current

    DESCRIPTION

        "Current status of the Cisco IP phone as seen

        on this device.

        onhook(1)  - Phone is on-hook.

        offhook(2) - Phone is off-hook.

        ringing(3) - Phone is ringing.

        paging(4)  - Phone is receiving an audio page."

    ::= { ccmeEphoneActEntry 4 }

Everyone's tags (2)
2 REPLIES
New Member

Re: How to use SNMP trap to monitor all the IP phones ?

I doubt the VG have traps related to call status.

What you can do is to poll the VG from time to time asking for the voice line status. You have posted the MIB to do the job already.

Note: I read IP Phone? aren't we talking about a VG? The MIB posted is for IP Phones.

New Member

Hi.I have a doubt: It's

Hi.

I have a doubt: It's possible configure SNMP community for Cisco IP Phones? I know that in CUCM Serviceability I can configure SNMP community, but this allows me to monitor and receive all data from CUCM.

If I need to get all information of Cisco IP Phones, how I can do that?.

Thanks.

827
Views
0
Helpful
2
Replies
CreatePlease login to create content