Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

https/ssl with CiscoWorks Browser

Is is possible to configure secured CW browser access using https or ssl certificates?

Thanks,

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: https/ssl with CiscoWorks Browser

There are no such things as CS 2.5 and 2.6, so I will assume you mean CS 3.0 for LMS 2.5 and 2.6. For LMS 2.2, you can only enable SSL mode if you do not have DFM installed. To enable SSL mode, go to Server Configuration > Administration > Security Management > Enable/Disable SSL.

For LMS 2.5 and higher, SSL can always be enabled. To do this, go to Common Services > Server > Security > Browser-Server Security Mode Setup.

3 REPLIES
Cisco Employee

Re: https/ssl with CiscoWorks Browser

Absolutely. What version of CiscoWorks are you using?

New Member

Re: https/ssl with CiscoWorks Browser

Thanks for the reply!

We are using CW Common Services 2.2, 2.5, and 2.6 on Windows 2000 and Solaris servers.

Thanks again,

Bob Schlifke

Cisco Employee

Re: https/ssl with CiscoWorks Browser

There are no such things as CS 2.5 and 2.6, so I will assume you mean CS 3.0 for LMS 2.5 and 2.6. For LMS 2.2, you can only enable SSL mode if you do not have DFM installed. To enable SSL mode, go to Server Configuration > Administration > Security Management > Enable/Disable SSL.

For LMS 2.5 and higher, SSL can always be enabled. To do this, go to Common Services > Server > Security > Browser-Server Security Mode Setup.

351
Views
0
Helpful
3
Replies