I have LMS 3.1 installed at one of our client site.
In HUM they are pulling the interface utilization repor
t for routers. we are observing the utilization valu
es comming in the reports are false. the values are in bytes/sec fomat. lets there is a link of 1 GbPS in one of my device. if i am converting the TX utilization in to Gbps it becames 4.04 Gbps. how it is possible that the tx load will reach to 4 Gbps on a 1 Gb link?
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...