Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

HUM thresholds: is it possible to watch a line in the graphs?

Hi,

I´m configuring HUM thresholds and I would like to watch them as a line in the graphs. By now, I haven't seen what I want. My question is: is it possible to do this?

Regards.

3 REPLIES
Cisco Employee

Re: HUM thresholds: is it possible to watch a line in the graphs

I'm not sure I follow.  If you're using LMS 3.2, you can use the LiveGraphIt portlet to graph an SNMP object value in real time.  You could then see if a threshold is violated by observing if the value crosses a given line.

New Member

Re: HUM thresholds: is it possible to watch a line in the graphs

Yes, I want to see the SNMP object in real time and a line in the same graph that would be the threshold configured for that poller. I've been creating Histo GraphIts and reports and I haven't been able to watch these threshold lines, only the SNMP object values. Do I have to configure something special to see it?

Cisco Employee

Re: HUM thresholds: is it possible to watch a line in the graphs

You cannot graph the threshold, but you can graph the MIB object value in real time using the LiveGraphIt portlet.  You can also view threshold violations in the Threshold Information portlet.

153
Views
5
Helpful
3
Replies
CreatePlease to create content