Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

I cann't archive running config from MSFC in LMS2.6

The following message appeared:

Execution Status : Job Execution Partially Successful for device

Execution Message : CM0057 PRIMARY RUNNING Config fetch SUCCESS, archival failed for 158.234.170.2 Cause: CM0002: Could not archive config Cause: Device may not be reachable, may be in suspended state or credentials may be incorrect. Action: Verify that device is managed, credentials are correct and file system has correct permissions. Increase timeout value, if required. Action: Verify that archive exists for device.

But I can download startup config from these two MSFCs:-( The credentials are OK and I tried to increase timeout but without success:-(

Can you help me, please?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: I cann't archive running config from MSFC in LMS2.6

It looks like the file system archive from this MSFC has been damaged. There are some missing files. Try deleting this device from RME, then re-add it. That should fix the problem.

4 REPLIES
Cisco Employee

Re: I cann't archive running config from MSFC in LMS2.6

You'll need to enable ArchiveMgmt Service debugging under RME > Admin > System Preferences > Loglevel Settings, then run a new archive sync for one of the failing MSFCs. Then post the dcmaservice.log.

New Member

Re: I cann't archive running config from MSFC in LMS2.6

Hi,

I'm sending you the dcmaservice.log file.

Cisco Employee

Re: I cann't archive running config from MSFC in LMS2.6

It looks like the file system archive from this MSFC has been damaged. There are some missing files. Try deleting this device from RME, then re-add it. That should fix the problem.

New Member

Re: I cann't archive running config from MSFC in LMS2.6

thank you. The config is archived for now.

Roman

127
Views
0
Helpful
4
Replies
CreatePlease to create content