If a server is disconnected from LAN , in show user command it is still shown ????
I am using cisco terminal server 2811 , during a test case we found that , when one of the server gets out of the network due to hardware failure , in the cisco terminal server it is still showing in the show user command.
Problem is we are using reusable ports , if this disconnected servers is not removed from the list , the other server is not able to use that port.
After 5-6 minutes , this disconnected server is not shown in the "show user " command , and the new servers gets connected to the ports.
My question , why there is a delay in the terminal server to recognize that the server is connected from the network.
We are pleased to announce availability of Beta software for 16.6.3. 16.6.3 will be the second rebuild on the 16.6 release train targeted towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are looking for early feedback from custome...