Is there any ifMIB bug, particularly concerning ifHCInOctets or ifHCOutOctets, for Cisco 7200 router running (C7200-SPSERVICESK9-M) 12.4(6)T1? I'm seeing large deltas (MIB counters decrementing) when polling those two OIDs with even 30-sec intervals.
All I know is the three ports are on the same module (number zero). Port 1 is gigabit SX, and media-type gbic. Ports 2 and 3 are both running 100mbit full, but gigabit-capable, media-type rj45. Only ports 1 and 2 cannot be reported, due to large delta in ifHCInOctets/ifHCOutOctets values, with either 30-sec or 5-min polling intervals. I have to switch to the following formula: (decode($(speedTotal),0.00,0.00,((((ifInOctets + ifOutOctets)*8)*100.0)/$(speedTotal))))/deltaTime to get those two ports's bandwidth utilization, per the reporting tool vendor's advice. The puzzle is why is Port 3 not affected? Is this a problem with the MIB agent in the IOS on the 7200?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...