My syslog server is blowing up with "ILPOWER-3-CONTROLLER_ERR: Controller error, controller number 0-4: accessing failed" messages from my 3550/3560-24/48-PWR-SMI switches running 12.2(46)SE. The Error Message Decoder was no help and I've been unable to find any docs with troubleshooting steps or bugs identified. The switches are both supplying and not supplying inline power to VoIP Phones and etc.
If anyone could point me to a troubleshooting guide or Cisco documentation that identifies that the alerts are non-impacting to the switch’s inline power capabilities that would be grand. Oh and possibly how to disable the alerts if that is the case.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...