Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Importing "tar" images into Software Repositiory - RME 4.0

Can anyone help provide some information on importing tar images from a Catalyst 3750 switch into the Software Repository. I created the tar file on the switch unit then start the "Add Image" process in the software repository...it gets as far as downloading then fails. The telnet log that it refers me too has no messages soo, it's no help. ".bin" files are no problem from the same test unit

5 REPLIES
Cisco Employee

Re: Importing "tar" images into Software Repositiory - RME 4.0

This is not possible. Only .bin images can be imported from devices.

New Member

Re: Importing "tar" images into Software Repositiory - RME 4.0

Sorry for the delay on responding again...so, you cannot bring up tar images from devices? You can download them from Cisco.com and put them into the software repository..seems odd that they didn't think of that when importing from devices.

Cisco Employee

Re: Importing "tar" images into Software Repositiory - RME 4.0

The problem is that there is no .tar file on the device to import. Once the .tar file is pushed to the device, it is extracted into a .bin image and related web management files. However, the .tar image can be found on Cisco.com.

New Member

Re: Importing "tar" images into Software Repositiory - RME 4.0

There is a command to create a tar image on the device though...I was able to to do that on one of the units but not successful in uploading to CW

Cisco Employee

Re: Importing "tar" images into Software Repositiory - RME 4.0

Even if you get a .tar image on the device, RME will not import it.

128
Views
0
Helpful
5
Replies