cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
569
Views
0
Helpful
3
Replies

Installation LMS3.2 - Regional Settings W2K3

STEFFEN NEUSER
Level 4
Level 4

Hello,

I want to install LMS3.2 at W2K3 server, but the installation will terminate complaining the regional settings, as shown in attached png.

But I set the regional settings to EnUS, as shown in attached png with reboot of the entire server. What did I wrong and what is the LMS installation looking for in real?

Steffen

1 Accepted Solution

Accepted Solutions

yjdabear
VIP Alumni
VIP Alumni

If your "systeminfo" output reflects all US English as well, maybe you can give the tip in the last post of this thread a try:

https://supportforums.cisco.com/message/673052#673057

"go to "regionnal setting",tab "advance" ,changed English(US) to FR and then back to English(US), do "Apply all setting to cur.." "

View solution in original post

3 Replies 3

yjdabear
VIP Alumni
VIP Alumni

If your "systeminfo" output reflects all US English as well, maybe you can give the tip in the last post of this thread a try:

https://supportforums.cisco.com/message/673052#673057

"go to "regionnal setting",tab "advance" ,changed English(US) to FR and then back to English(US), do "Apply all setting to cur.." "

STEFFEN NEUSER
Level 4
Level 4

100 points, problem solved, thx Steffen

Es war mir ein Vergnuegen.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco