Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Interface Status not shown in DFM

Hi everyone!

DFM does not receive interface and subinterfaces status (admin/oper)about MSR 8510 though i am receiving threshold alerts. Checking the configuration, below are the only config defined:

logging x.x.x.x

snmp-server community xxxx RO

snmp-server community xxxx RW

Missing is the:

snmp-server x.x.x.x

could this be the reason?

3 REPLIES
Cisco Employee

Re: Interface Status not shown in DFM

Certainly link traps help DFM, but it should be able to determine that kind of information from polling. Admittedly, the 8500 series is old and end of life, and could have numerous SNMP instrumentation issues. This might be related to such an issue.

You should check the ifTable (ifOperStatus/ifAdminStatus) for the interfaces that are transitioning state on this device, and verify that the correct state is being reported via SNMP.

New Member

Re: Interface Status not shown in DFM

hi jclarke!

how can i do that then?

thanks...

Cisco Employee

Re: Interface Status not shown in DFM

You can use the SNMP Walk tool in the CiscoWorks Device Center to walk the ifTable of this device.

113
Views
4
Helpful
3
Replies
CreatePlease to create content