WARNING:%FIB-4-FIBBADSNMPPREFIX: Invalid prefix passed to CEF SNMP walker ([IP_address][IP_netmask])
Explanation: when SNMP is polling the routing table, Gateway may generate tracebacks following with the above error message.
Recommended Action: Please upgrade the ios image to fixed / latest version.
Below is from Cisco Site:-
Related Bug Information
SNMPwalking ipRouteTable may result in %FIB-4-FIBBADSNMPPREFIX traceback
Symptom: Doing snmpwalk of ipRouteTable in RFC1213-MIB, it may result in some traceback as seen below: Mar 5 22:31:33.980: %FIB-4-FIBBADSNMPPREFIX: Invalid prefix passed to CEF SNMP walker (0.0.0.1/0). -Traceback= 0x611C46F8 0x614A9944 0x6170CBF4 0x6170D1D4 0x61F520D8 0x61F56008 0x61F46F40 0x61F6F8B0 0x621E1560 0x621E1544 Conditions: This has been observed on the C3800 routers running 12.4(12a). Other versions and platforms may also be affected. Workaround: Create an SNMP view to block the SNMP server to poll the ipRouteTable. Here is an example: conf t snmp-server view cutdown internet included snmp-server view cutdown ip.21 excluded snmp-server community view cutdown RO
Cannot discover the Router using CA Ehealth after enabling IOS based IPS
Symptom After turning on the IOS IPS feature on a 2821 Router , it cannot be redicovered in CA Ehealth using SNMP. Workaround Workaround is to un configure the IOS IPS feature and then discovery starts working again.
They have suggested a workaround. Tried doing below configuration but no luck.
The configuration is wrong. The workaround would be:
snmp-server view cutdown internet included
snmp-server view cutdown ip.21 excluded
snmp-server community COMMUNITY cutdown RO
Where COMMUNITY is the your current SNMP community string. You would then poll the device with that community string. The downside of this workaround is that you can no longer poll the routing table. This may hinder network discovery or other management tasks which rely on the rotuing table. The recommended solution is to upgrade to 12.4(12b).
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...