The problem here is most likely the code. RME uses the ENTITY-MIB to get the serial number information from the PIX. If the PIX is not reporting the serial number, then RME will not be able to show it. Post an SNMP walk of the entPhysicalTable (220.127.116.11.18.104.22.168.1.1).
I should add that if all you want to do is be able to see the serial number within RME (i.e. without getting it in the inventory reports), you could use Netshow to do this. Assuming there is a show command which provides the serial number (e.g. "show ver"), you could run a Netshow job from RME > Tools > Netshow to execute that command, then you can view the results.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.