I have installed a LMS 2.5 in solaris platform , in this I have faced some problem.
In our backbone network have 14 Cisco 7609 OSR routers & 4 Cisco 21010 GSR routers.
In config management I have get the configuration change info from the OSR with normal SNMP RO community string with telnet username & password but not for GSR then I have added the enable password for GSR then I have get the GSR's config changes in LMS.
Now in inventory management I have get the all OSR hardware & software (IOS) info report but not the GSR's can you please tell me what's are the possible causes & how do we resolve it.
2ndly in Cisco view I have not found SPA 200 module in OSR, Cisco view shows unknown module.
In order to get configurations from devices you must have either read-write SNMP credentials, enable access via telnet or SSH, or read-write access via RCP or SCP. There is no way to fetch a config from a device using only SNMP read-only or a disabled interactive shell. The account you are using for your OSR routers must automatically be enabled when logged in, or you have more credentials in DCR that you realize.
As for CiscoView, what version of the Cat6000IOS package do you have installed?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...