I've setup a couple of FWSM contexts previously to perform config archiving.
I followed the steps previously outlined (enable SNMP, configuring the Polling community, firewall port opening, etc..)
however, this newest FWSM, does not give an inventory failed error, it merely doesnt display information in Device Center. the only available information are the tools..Not sure why the inventory is not occurring...of course, it doesnt show up in devices to add to RME.
I can SSH from the LMS server to the FWSM context and can SNMP walk the module.
Adding the device to DCR usually means that RME will automatically manage the device. However, if you have disabled auto-allocation in RME, or if RME missed the update from DCR, it may not be managed. Go to RME > Devices > Device Management > RME Devices, and click the Add button. See if the device shows up there.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...